Pr
oduct Featur
es
Page 32
temperature set to 24°C.
• If there is a power failure while the unit is running, the
compressor starts 3 minutes after the unit restarts. If
the unit was already off before the power failure, the
compressor starts 1 minute after the unit restarts.
1.11 Refrigerant Leakage Detection
• With this new technology, the display area will show
“EC” when the outdoor unit detects refrigerant
leakage.
• When compressor is active, the value of the Coil
temperature of evaporator T2 has no change or very
little change.
1.12 Self clean(Optional)
• If you press “Self Clean” when the unit is in cooling or
drying mode:
• For cooling models, the indoor unit will run in low
fan mode for a certain time, then ceases operation.
• For heat pump models, the indoor unit will run in
fan-only mode, then low heat, and finally in fan-
only mode.
• Self Clean keeps the indoor unit dry and prevents
mold growth.
1.13 Follow me(Optional)
• If you press “Follow Me” on the remote, the indoor
unit will beep. This indicates the follow me function is
active.
• Once active, the remote control will send a signal
every 3 minutes, with no beeps. The unit automatically
sets the temperature according to the measurements
from the remote control.
• The unit will only change modes if the information
from the remote control makes it necessary, not from
the unit’s temperature setting.
• If the unit does not receive a signal for 7 minutes or
you press “Follow Me,” the function turns off. The
unit regulates temperature based on its own sensor
and settings.
2. Remote Controller Functions
2.1 Infrared Wireless Remote Controller
R51M/E(Standard)
Remote Controller Specifications
Model
R51M/E
Rated Voltage
3.0V (Dry batteries R03/
LR03×2)
Reaching Distance
8m
Environment Temperature
Range
-5
℃
~60
℃(
23
℉
~140
℉)
Buttons and Functions
1. TEMP DOWN Button : Push this button to decrease the
indoor temperature setting in 1
℃
increments to 17
℃.
2. TEMP UP
Button: Push this button to increase the
indoor temperature setting in 1
℃
increments to 30
℃
3. MODE Button: Once pressing, running mode will be
selected in the following sequence:
NOTE: No heating mode for cool only type unit.
4. SWING Button: Push this switch button to activate auto
swing feature of the horizontal louver. Push it again to
Summary of Contents for Forest MOAA31-12CN1-NB8
