Service Manual_2018-V2.0
46
The fault code shall be displayed when there is a fault (cyclic display); the set temperature of
the refrigerating chamber shall be displayed when there is no fault.
10.3Temperature control
1) Temperature adjustment of refrigerator compartment
Press “REF. TEMP” button, then press “REF.TEMP” to adjust setting temperature, the setting temperature
is changed circularly “7
℃
6
℃
1
℃
7
℃
……” or“44
℉
℉
℉
℉
……”
2) Temperature adjustment of Freezer compartment
Press “FRZ. TEMP” button, and then press “FRZ. TEMP” to adjust setting temperature , the setting
tempera
ture is changed circularly “-14
℃
-15
℃
...
-22
℃
-14
℃
……” or“ 7
℉
6
℉
...
-7
℉
7
℉
……”
3
）
Frequently-used MODE
Long press the refrigerating button for 3s to set /cancel the quick refrigerating mode;
Long press the freezing button for 3s to set /cancel the quick freezing mode;
Short press the ENERGY SAVING button for 3s to set /cancel the ENERGY SAVING mode;
Fast freezing mode:
the freezer compartment will work as the setting temperature is 1
℃
/ 34°F
，
when the quick freezing mode
is exited, the set temperature in the refrigerating chamber shall be automatically restored to the set
temperature before the quick refrigerating mode;
Fast cooling mode:
the refrigerator compartment will work as the setting temperature is -22
℃
/-7°F
，
when the quick freezing
mode is exited, the set temperature in the freezing chamber shall be automatically restored to the set
temperature before the quick freezing mode;
ENERGY SAVING mode:
the refrigerator compartment will work as the setting temperature is 7°C/44°F, while the freezer
compartment will work as the setting temperature is -14°C/7°F;
When the ENERGY SAVING mode is exited, the set temperature in the refrigerating and freezing
chamber shall be automatically restored to the set temperature before the ENERGY SAVING mode;
When the ENERGY SAVING mode setting is valid, the ENERGY SAVING indicator shall light up
otherwise it shall go out.
10.4 Open door alarm
When refrigerator door or freezer door is open, the display panel is light on. There is notification tone
when open door; if refrigerator door or freezer door is open last for 120s, there will be buzzer alarm, until
the door is closed
。
Press any buttons on control panel can cancel this buzzer alarm.
Note: When open the door, the display panel is light on; when the door is closed, the display panel will be
light off after 30s if there is no any operation on display panel
10.5Function Selection
1) Mandatory mode (mandatory compressor starting, mandatory defrosting and mandatory ice
making)
All below functions are only for diagnosis purpose, we advise to restart the refrigerator by power on/off if
have used these functions.
Buttons operation:
Press both “LOCK/UNLOCK” and “FRZ.TEMP” button last for 3s to enter into/quit mandatory mode, the
setting will take effect after locking.
Press “FRZ.TEMP” button, the ref. temperature zone will display “1” “2” “3” “4” circularly,
Summary of Contents for HC-957WEN
