10 Push the water supply hose into the water inlet hose as far
as it will go and tighten the Nylon compression nut onto the
water inlet hose until it is secure/tight.
Then tighten the nut until it is secure but DO NOT
overtighten using a wrench.
11 Install the leveling bracket to the bottom of the ice maker
assembly with the screw provided.
DO NOT TIGHTEN.
This bracket will be tightened later in this installation.
12 Start two (2) long ice maker mounting screws into the
freezer wall.
Turn each screw five turns clockwise.
13 With the ice maker in one hand, plug the wiring harness
connector into the connector mounted on the top freezer
panel.
Make sure the connection is tight and secure.
14 Mount the ice maker assembly on to the two (2) screws
installed in step # 11.
Tighten the screws.
Be sure that the water inlet tube is securely inside the fill
cup.
9
Slide the hose through the hole of the security bracket and
the foam insulation pad, with the pad facing the rear of the
refrigerator and affix the hose security bracket and foam
insulation pad in place using the two (2) screws provided.
10
