R410A Full DC Inverter Split Duct Type Technical Manual MCAC-UTSM-201503
57
than 10 hours, each press
or
will increase or decrease 1 hour, the maximum timer
setting is 24 hours.
After finish adjusting the timer on setting, press the button
or wait for 5 seconds to
confirm and exit the timer on setting.
Under the timer on setting status, press the timer/clock setting button
, then enter into the
timer off setting status, and the screen will display
and
.
The setting method of timer off is the same as the timer on.
Under timer setting state, set the timer on and the timer off to be 0.0h can cancel timer on and
time off.
Notes: If the wired controller has been set timer on/off, press the ON/OFF to turn on or turn off the unit
then the timer will be canceled simultaneously.
7) Clock setting
Press the timer/clock button
setting for 3 seconds, and then enter into the clock setting
status.
The hour position of the clock will flash, and can press
and
to adjust the hour value.
After finishing the hour setting, press left button
or right button
to switch to
minute position setting, then the minute position will flash, press
and
to adjust the
minute value.
After finish the clock setting, press the
button or wait for 5 seconds to confirm and exit
the setting state.
8) Quiet operation
Under COOL, HEAT, FAN modes, press the
button to set into the quiet operation, it is
used to reduce the running noise through setting the fan speed to low.
Notes: Under AUTO, DRY mode, the fan speed is auto and the
button does not work.
