Sa
f
C
a
re
Tr
u
b
le
o
o
tin
Use
ICES Warning
This
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
device complies with Industry Canada’s licence-exempt RSS.Operation is
This
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
equipment complies with RSS radiation exposure limits set forth for an
IC
radiation exposure limit set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm between the
radiator and your body.
Radiation Exposure Statement: This equipment complies with IC RSS-102
Déclaration
d’exposition aux rayonnements IC définies pour un environnement non contrôlé.
Cet équipement doit être installé et mis en marche à une distance minimale de 20
cm qui sépare l’élément rayonnant de votre corps. L’émetteur ne doit ni être utilisé
avec une autre antenne ou un autre émetteur ni se trouver à leur proximité.
(source : https://sgcdn.startech.com/005329/media/sets/USB300WN2X2C_Manual
/USB300WN2X2C_QSG.pdf)
d’exposition à la radiation: Cet équipement respecte les limites
Le
appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d’en compromettre le fonctionnement.
(Source :https://support.polar.com/e_manuals/M400/Polar_M400_user_manual_
Francais/Content/Compliance_Statement.htm)
présent appareil est conforme aux CNR d’Industrie Canada applicables aux
FCC Caution
Note:
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
•
•
•
Consult the dealer or an experienced radio/TV technician for help.
The distance between user and device should be no less than 20cm.
Any
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This
device complies with part 15 of the FCC Rules. Operation is subject to the
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits