Midea MSV1-09HRN1, User Manual

Special function 

Air quality is the key to comfort, this air conditioner is equipped with Ionizer device.
Ionizer can generate abundant anions to fill the room with refreshing and nature air.
Your whole family will enjoy a natural, pure and healthy air everyday.
 

CLEAN AIR function

6

When turns off the unit  on COOL, DRY, AUTO (Cool) mode, the air conditioner
will continue operating for 10 minutes at LOW fan speed. This will help to dry up the 
water (sweating) inside the evaporator, and prevent bacterial from multiplying, 
supply clean and fresh air.
This function is a factory default setting. If you want to cancel it, use the remote 
controller to select the  FAN mode, press the ON/OFF button to turn on the unit,
press the ON/OFF button again to turn off the unit after 5 seconds.

 Under DRY & Antibacterial mode, do not restart the air conditioner until the unit is
 completely off.  

Function used after the Shut Down of cooling operation to clean the Evaporator 
and keep it as fresh for the next operation. This function is easy to be operated 
as it is accessed through the Remote Controller. 
For cooling only models, the air conditioner will operate under FAN ONLY  mode 
at LOW fan speed for 30 minutes, and then stop the operation and the unit turn off.
For cooling & heating models, the air conditioner will operate : FAN ONLY
mode at Low fan speed(13 minutes)--Heating operation with LOW fan speed
 (1 minute)---FAN ONLY operation(2 minutes)--Stop Operation---Turn off the unit. 

Note:

This function is only available under COOL(AUTO COOL, FORCED COOL) and 
DRY mode. 
Before select the function, it is recommended to run the air conditioner under 
Cooling operation for about half an hour.
Once the Auto Clean function is activated, all TIMER setting will be cancelled.
During Auto Cleaning operation, Press the AUTO CLEAN button again  will stop
the operation and turn off the unit.

Auto Clean  function(optional)

Follow Me function 

Dry & Antibacterial function

To activate the Follow Me feature, point the remote control towards the unit and 
press the Follow Me button. T

 If the unit does not receive the 

Follow Me signal during any 7 minute interval, the unit will beep to indicate the 
Follow Me  mode has ended. 

he remote display is actual temperature at its location. 

The remote control will send this signal to the air conditioner  every 3 minutes 
interval until press the Follow Me button again. 

The remote control serves as a remote thermostat allowing for the precise 
temperature control at its location.