Midea NTH20R, Manual

PRODUCT SPECIFICATION

Model

Low

High

Power regulation range 

NTH20-21R 1200W 2000W 1200W

2000W

Low osc High osc

TROUBLESHOOTING

If the product does not operate or does not operate properly, first check according to the following 

list. If the reason the product does not operate or does not operate properly is not included in the 

following list, the product mayhave failed. At this time, it is recommended to send the product to 

the dealer for treatment.

Problem 

Possible Cause 

Solution 

After the power is 

engaged,the machine 

does not work

.

The plug may not be 

plugged well. 

Check whether the plug is

properly inserted in to the

receptacle. 

The machine suddenly 

stops during heating.

The temperature exceeds  

the threshold of the 

thermal cut- o . 

  then in sert it into the receptacle

  again 

when the machine is cooled.

CLEANING AND MAINTENANCE INSTRUCTION

1. The electric heater should be cleaned regularly to wipe out the dust on the surface of flanges. 

    As this may influence the radiating efficiency.

2. Disconnect electricity supply and allow radiator to cool, wipe out dust with a soft damp cloth. 

    Do not use detergent or abrasives.

3. Do not scrap the surfaces of flanges with sharp hard tools,  prevent damage of the paint coat.

Remote control

Turn on/off 

the Swing

button

ON/OFF button

Funtion button 

Button of temperature / time increase 

Timing button 

(AAA battery 1.5V)

Power assembly 

drawing

Button of temperature / time 

decrease 

ECO button 

Control range of remote controller 

The remote controller control can be normally 

used within 5 meters in front of the product 

and in the left and right angles of 30 degrees. 

Please use a manganese or alkaline battery 

of type "AAA" and do not use a non-recycla

-

ble battery.

Power 

supply 

220-240V~

  50-60Hz

199x209x603mm

2.8kg

Product size

   (LxWxH)

Net 

weight 

and

6