2) press CC No.(will be shown in display)
3) choose 7 on numeric keypad;
4) press enter key to specify Control Change as 7;
5) the display shows “---“
6) press CC DATA.(will be shown in display)
7) Press number key 1, 2, and 3, then press enter key to specify value 123 then press
Data Entry knob to finish this action.
9) For Velocitiy, Referb and Chorus Depht, Pan Pos, Volumen you only need to enter CC
Data Value.
Please note for e.f.g.: after you press enter key the LED display will show --- to indicate that you
pressed enter key and will not disappear until you press Data Entry knob to finish your choice. After
you press cancel key the LED display will show blank to indicate that you pressed cancel key and
will not disappear util you press Data Entry knob to finish your choice.
Program key
Pressing Data Entry knob then the Program key, then numeric keys and then enter key,
you can select any patch number between 1 to 127. For example, if you want to change
voice to 67 (Tenor Sax): Press Data Entry knob and 67 on numeric keys, enter key and
then Data Entry knob again to finish this action.
Assignment of the 12 Real-time Controllers
In order to assign a Controller Knob to a MIDI Parameter (MIDI Controller) please follow
these steps:
1. Press Data Entry knob then SET CONTROLLER key (F3)
2. Choice number of knob on ten key groups (1 - 12) then press enter
3. Assign controller number on ten key groups (1-127) then press enter
4. Assign act channel number on ten key groups (1-16) then press enter
5. Finally, press Data Entry knob key again to finish assign knob.
Now you have assigned to one Control knob the MIDI Parameter and the MIDI Channel
and stored in the actual setted presetbank. Repeat the same method for the other 12
Real-time Controller Knobs.
Selecting and setting a Presetbank
There are 15 presetbanks with predefined controller settings, each with 12 controllers
(Midichannel, Midicontroller Nr.)
All settings are stored in an EE-Prom to be sure at power off or battery change state.
At the end of this usermanual you can find a list with the factory settings of the controllers.
Summary of Contents for i2 Control-37 black edition
Page 1: ...Control 37 Usermanual...
Page 22: ...Control 37 Bedienungsanleitung...
Page 43: ...Control 37 Mode d emploi...
