Midland BT Remote, Manual

UK

  Midland BT Remote -

 7

Switching your Midland BTRemote on and off:

Switching the unit on: 

Press and hold “Middle” button down for approximately 3 seconds until the BLUE 
indicator lights up. 

Switching the unit off: 

Press and hold both “Middle” and “Backward” buttons together for approximately 
3 seconds until the RED indicator flashes 3 times, thus lessening the chances that 
you might turn off the unit accidentally (especially whilst wearing gloves). 

Operative mode

Midland BTRemote replicates exactly the same functions as the 5 buttons avai-
lable on the BT Next, BTX1 and BTX2 intercom, therefore you can refer to the 
intercom manual.

How to  pair the BTRemote

Midland BTRemote can be paired to the following intercoms: BTNext, BTX1 and 
BTX2.

First time pairing

The BTRemote is ready to be paired just out of the box:

›

 Turn on the BTRemote (Press and hold “Middle” button down for 3 seconds, 
the blue light will start flashing)

›

 Turn on the intercom (BTNext, BTX1, BTX2)

›

 Press any button on the BTRemote ( you must do it within 3 minutes after you 
turned on the intercom unit)

The two devices will search for each other and they will automatically pair. 
Once the pairing procedure is completed, it does not to be repeated again, becau-
se the BTRemote will automatically recognize the paired unit.  
If the pairing procedure fails, just repeat the procedure again. In case the pairing 
still does not work, perform first a reset (see the “How to reset the pairing” para-
graph) and than repeat the procedure.

Using the BTRemote

To use the BTRemote, simply switch it on and press any button (make sure that 
the intercom is on). This ensures the connection and as soon as the blue light 
starts double flashing, you can start using it.

How to reset the pairing 

Sometimes you may find it necessary to delete all the pairing references stored in 
the BTRemote unit (reset operation):

›

 Turn off the unit 

›

 Press and hold down the “Middle” and the “” buttons together, until 
the Blue light turn on steady.

›

 Release the buttons and the blu light will start flashing 

Now all the pairing information are deleted and it is possible to start a new pai-
ring session (as explained in the paragraph “First time pairing”):

›

 While the blu light is flashing, just turn on the intercom unit (BTNext, BTX1, 
BTX2)

›

 Press any button on the BTRemote ( you must do it within 3 minutes after you 
turned on the intercom unit)

The two devices will search for each other and they will automatically pair.