MNBE-B, D, D3R, E Instructions
(continued)
Rev: A Page 3 of 10
Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.
Wear complete eye and clothing protection. Always avoid touching eyes while working near
batteries. If battery acid or battery terminal corrosion contacts skin or clothing, wash
immediately with soap and water. If acid enters the eyes, immediately flood with cool running
water for at least 15 minutes and get medical attention immediately. Baking soda neutralizes
battery acid electrolyte. Keep a supply near the batteries.
Do not work alone. Someone should be in the range of your voice or close enough to come to
your aid when you work with or near electrical equipment.
Remove rings, bracelets, necklaces, watches etc. when working with batteries, photovoltaic
modules or other electrical equipment. Power from an illuminated photovoltaic array makes a
very effective arc welder with dire consequences if one of the welded pieces is on your person.
To reduce the risk of injury, connect only deep cycle lead acid type rechargeable batteries. Other
types of batteries may leak or burst, causing personal injury or damage.
Assembly Instructions
Hardware kit contents
Midnite PN Description
MNBE-B MNBE-D MNBE-D3R MNBE-E
3-089-1
Fan hole cover plate 1.75”
1
1
-
1
3-095-1
Fan hole cover plate GJ1
1
1
-
1
5-029-1
Midnite Solar Badge
1
1
1
1
6-006-1
10-32 X 3/8 Machine Screw
-
-
16
-
6-029-1
#10 X 3/8 Flat Head Screw
9
13
9
13
6-057-1
#6 X 3/8 Screw Type A 82
○
25
25
25
25
6-088-1
#10 X 3/8 Screw Type B
40
40
21
40
9-052-1
Hinge
2 PKG (2) 2 PKG (2) 2 PKG (2) 2 PKG (2)
9-204-1
Keyed Handle
1
1
1
2
9-205-1
Pawl
1
1
1
1
9-213-1
Hole Plug
-
-
-
2
10-016-1
Assembly Instructions
1
1
1
1
Preparation:
You will require a #2 Philips screw driver and a 5/16” wrench to tighten screws, as well as a
slotted screw driver and hammer to remove knockouts.
Step 1:
Attach shelves to the two sides as shown below.
Use eight #10 x 3/8” sheet metal screws.
4 Screws per shelf. Bottom shelf is the floor of the unit.
Step 2
:
#10 x 3/8” Stainless Steel
Hex head sheet metal screw
