SMA E-Panel installation manual
13 |
P a g e
1 0 - 2 3 4 - 1 R E V : A
Mounting the SMA E-Panel to the wall continued:
Above:
Quad system with Battery Combiner.
Studs are shown for reference and are at 16” centers.
If mounting on plywood use ¾” material.
Use a minimum of eight 1/4” screws per backplate.
Pre-Wired Systems:
Systems are available pre-assembled / pre-wired. It is not necessary to disassemble
systems to mount them on the wall. One way to install a pre-Wired system is to find where the bottom of the
backplate will be when installed and securely screw a 2x4 to the wall with the top just at where the backplate
will be. Place the bottom of the backplate on the 2x4 and have two people tip it up into place and secure the
backplate to the wall with a minimum of 8 ¼” screws at least 2” long.
Left Side knockout location
Front
Top
2/0 Battery cable lengths necessary to complete
installation as shown above:
E-Panel
Positive
Negative
#1
71”
71”
#2
45”
41”
#3
30”
44”
#4
60”
75”
