10.
19.
20.
21.
22.
Unbend the loop of the knuckle you identified so that it is straight. Locate the corresponding knuckle at the
bottom of the Chain-Link Fence. Unbend that loop. This single “picket” can now be removed. Lift and rotate the
picket until it is completely removed from the fencing.
Use pliers to grip the exposed threads and snap off the
excess at the scored area of the bolt. Finish each nut
with a Plastic Cap (Q).
Once all excess fencing has been removed, insert the second Tension Rod down through the Chain-link Fence and
the Eyebolts on the other side of the gate, as you did in Step 15.
Facing the Kennel, go to the top, left Eyebolt. Push the
“eye” firmly against the Gate Frame. Tighten the Nut past
the scored area of the bolt’s threads. Move down to the
next Eyebolt and repeat. Pulling the Tension Rod against
the Gate Frame as you go, proceed around the Gate
Frame until all eight Eyebolts have been tightened. This
step will tighten the fit of the Chain-Link Fence around
the frame.