Brief instructions
a
AutoDos (automatic dispensing)
b
Detergent compartment
c
Rinse aid reservoir
d
Salt reservoir
e
Filter combination
Filling the salt reservoir
Remove the lower basket from the
wash cabinet and unscrew the salt
reservoir cap.
Damage to the water softener
from detergents.
Dishwasher detergent will damage
the water softener.
Do not fill the salt reservoir with
powder or liquid detergent.
Risk of corrosion due to saline
solution.
Water or saline solution will run out
of the reservoir when the cap is
opened. Saline solution that runs out
can cause corrosion in the wash
cabinet and to the dishwasher load.
The salt reservoir should therefore
only be opened to replenish the salt.
Fill the salt reservoir with approx. 2 l
of water (first use only).
Place the funnel provided over the
salt reservoir and carefully fill with
dishwasher salt until the reservoir is
full.
Clean any excess salt from around
the reservoir opening and then screw
the salt reservoir cap on again firmly.
Immediately after filling the salt
container, run the
QuickPowerWash
65 °C programme with the
Express
option and without any
load in the dishwasher to dissolve
and remove any traces of salt from
the cabinet.
