en - Areas of application
26
Preparing the insert
Remove the upper basket from the machine.
Pull the lower basket out of the wash cabinet onto the machine
door.
Place the insert into the lower basket.
The rear panel of the insert is facing the rear panel of the wash cab-
inet.
Preparing the load
Pre-cleaning the
carrier frame
Check whether the carrier frame requires manual pre-cleaning, e.g.
to remove soot.
If required, carry this pre-cleaning out in line with the manufac-
turer’s instructions.
Inserting the car-
rier frame
Carry straps that point upwards can get caught in the machine
spray arm and affect the cleaning result or can tear off the spray
arm or damage the machine when the insert is removed.
Place the carrier frame in the front part of the insert with the carry
straps pointing downwards.
Lean the carrier frame diagonally against the support grid in the rear
part of the insert.
The carry straps must hang loose to ensure the wash water cleans
and rinses them completely.
Push the lower basket with the insert into the wash cabinet.
After reprocessing
It is essential that you pay attention to the “Application technology”
chapter in the operating instructions for the dishwasher or the ma-
chine and the instructions specified by the manufacturer of the carrier
frames for compressed air units.
