en - Areas of application
39
Adjusting the upper basket
The A 105/1 upper basket can be adjusted between three positions
with approx. 30 mm between each position to accommodate items of
different heights.
To adjust the height, the brackets with rollers on the side of the upper
basket and the water connector at the back of the basket have to be
moved. The roller brackets are each secured to the upper basket by
two screws. The water connector consists of the following compon-
ents:
– 1 plastic connector
– 2 plastic blanking covers
– 3 screws
Adjust upper baskets horizontally only. The baskets are not de-
signed for tilting (one side up, one side down).
Adjusting the height alters the vertical clearance of the upper and
lower baskets.
To adjust the up-
per basket
Remove the upper basket by pulling it out until a resistance is felt
and lifting it off the runners.
Unscrew the roller brackets and the water connector.
Adjusting the height of the upper basket
Upper position
Move the roller brackets on both sides to the lower position and
screw them tight.
Insert the connector into the opening at the bottom and click it into
place by pushing it to the left as far as it will go. Screw the con-
nector tight. Attach the blanking covers to the two openings above,
click them into place and screw them tight also.
