en - English
33
Warning and safety instructions
This Connector Box box complies with all relevant current safety requirements. Inappro-
priate use can, however, lead to personal injury and material damage.
First read these operating and installation instructions for the Connector Box box. They
contain important information on the safety, use and maintenance of the Connector Box
box. This prevents both personal injury and damage to the appliance.
Keep these instructions in a safe place and pass them on to any future owner.
Appropriate use
The Connector Box box is intended to be used solely to establish a connection between
a Miele Professional machine and external hardware, such as a peak-load negotiation sys-
tem, a coin payment system, an additional fan, an exhaust valve or dispenser pumps. Any
other applications may be dangerous.
Miele cannot be held liable for damage resulting from incorrect or improper use or opera-
tion.
The Connector Box box is intended to be used exclusively in conjunction with Miele Pro-
fessional machines with a connection coupling that has been fitted at the factory.
Technical safety
The Connector Box box must only be installed and assembled by qualified electricians
who have made sure that the conditions for its correct use are met.
Before installation, check the Connector Box box for visible signs of damage. Do not in-
stall or use a damaged Connector Box box.
The Connector Box box must not be repaired in the event that it displays a defect or
damage.
In such cases, the Connector Box box must be replaced by a new one.
The Connector Box box is only disconnected from the mains power supply if the Miele
Professional machine has been disconnected in accordance with the specifications
provided in the operating and installation instructions.
The connection cables between the Miele Professional machine and Connector Box box
must not become trapped.
The Connector Box box must be assembled on site or mounted on the machine with a
special machine attachment (optional accessory).
The Connector Box box must be accessible after being mounted on a wall to enable
service work to be carried out.
The connection cables for the Connector Box box must be assembled and routed cor-
rectly.
The cable strain relief fixtures as well as the cable glands and counter nuts supplied by
the factory to connect external hardware must be used.
Summary of Contents for Connector Box
Page 149: ... 149 ...
