Cleaning and care
120
At the end of the Self Clean program
When the duration remaining reaches
00:00 h, a message will appear in the
display to tell you that the door is
unlocking.
When the door lock has been
deactivated:
–
Program Finished
appears in the
display,
– A buzzer will sound if turned on (see
"Settings - Volume - Buzzer tones").
Turn the oven off.
Acoustic and visual signals are turned
off.
Danger of burns!
Danger of burns! Wait until the oven
has cooled down before removing
any residual soiling left in the oven
compartment from the Self Clean
program.
Wipe any residues (e.g.ash) left
behind after the Self Clean program
out of the oven compartment and off
of any accessories. The amount of
ash will vary depending on how dirty
the oven was.
Most soiling can be easily removed
using a clean, soft sponge and a mild
solution of warm water and liquid dish
soap.
Depending on the degree of soiling
before cleaning, there may be a visible
layer of soiling across the inner glass
pane on the door. This should be
removed using the scouring side of a
dish sponge or with a stainless steel
spiral sponge and liquid dish soap.
After the Self Clean program pull the
FlexiClips with wire rack apart several
times.
Please note:
– There is a seal around the oven
interior which seals the inside of the
door. Take care not to rub, damage
or move the gasket.
– The FlexiClips with wire rack may
appear discolored or a lighter color in
places after they have been cleaned.
This will not affect the function of the
runners in any way.
– Spilt fruit juices may cause lasting
discoloration to enameled surfaces.
This discoloration is permanent but
will not affect the efficiency of the
enamel. Do not attempt to remove
these marks.