Fitting the non-return flap
(Air extraction mode only)
^
If a non-return flap is not present in
the venting system, the non-return
flap supplied must be fitted onto the
exhaust socket in the motor unit. The
flaps must open upwards.
Building in
The rangehood is intended to be built
into wall units, rangehood housing
units, and above breakfast bars or
island areas.
Check prior to installation that the top of
the appliance will be accessible after
installation.
If this is not the case, install the exhaust
ducting and prepare the electrical
connection
before
installation.
^
Place the appliance in the cut-out
from below and align it.
^
Secure the rangehood by the frame
using 3.5 x 16 mm screws.
^
Before using the appliance for the
first time, take the grease filters out
and remove the protective foil from
the filter frame. Then replace the
grease filters.
Installation
18
Summary of Contents for DA 2050
Page 27: ...27 ...
Page 28: ...Alteration rights reserved 3013 M Nr 09 723 310 00 ...