The standard settings listed in the chart can be altered. Several settings can be
altered in succession.
Programme
Display
Setting
P 1
Demo-mode
OFF
the appliance will heat up
ON
the appliance will not heat
up
P 2
Audible tone volume
S1 to
S4
The higher the number, the
louder the audible tone
P 3
Water hardness
1
Soft
2
Medium
3
Hard
4
Very hard
* The factory default settings are shown in bold.
Proceed as follows:
Before you begin, ensure that the
appliance is
switched off
.
^
Press the function selector gently in
and turn it anti-clockwise slightly.
^
Then release the function selector.
"P1" will appear in the display.
^
Turn the function selector until the
programme you want to alter
appears.
^
Confirm your selection by pressing
the function selector.
^
Then turn the function selector until
the setting you want appears.
^
Confirm your selection by pressing
the function selector.
^
After you have altered the settings,
press the function selector until the
display goes out.
Programming
39
Summary of Contents for DG 1050
Page 50: ...50 ...
Page 51: ...51 ...
Page 52: ...Alteration rights reserved 3209 M Nr 06 643 810 04 ...