Coupling seal
If the water container becomes difficult to remove and
replace or the fault message
F20
appears, rub a small
amount of the silicone grease supplied (see "Guide to the
appliance / Accessories supplied") into the inside of the
coupling seal. Do not take the seal out to lubricate it!
When handling silicone grease, please observe the following
safety measures:
– Remove any silicone grease from your skin either by
wiping it off or by washing it off.
– If the grease gets into the eyes, it must be rinsed out with
plenty of clean water.
– If it is swallowed, seek medical advice.
The coupling seal should be replaced with a new one if it
becomes brittle or porous or if an unusually large amount of
water collects on the floor of the water container
compartment.
Coupling seals can be ordered from the Miele Spare Parts
Department.
Only use the silicone grease supplied. On no account
must margarine or oil or any other domestic grease or fat
be used, as these can cause the seal to swell.
Cleaning and care
43
Summary of Contents for DG 5070
Page 62: ...62 ...
Page 63: ...63 ...
Page 64: ...Alteration rights reserved 4810 M Nr 07 207 620 05 ...