Operating the Ice/Water dispenser
89
Switching on the Dispenser
Unit
Ice cubes can only be made when the
ice container is completely closed.
In Settings mode
, use the
and
sensor controls to select the
Dis-
penser Unit
and select
OK
to confirm
your selection.
Use the
and
sensor controls to
select
On
and select
OK
to confirm
your selection.
Close the appliance door.
The Ice/Water dispenser is now ready
for operation.
All sensor controls in the Ice/Water-dis-
penser control panel should now be
highlighted in white.
If this is not the case, the system lock
has been activated (the
sensor con-
trol will be highlighted in white, see
“Operating the Ice/Water dispenser –
Switching the system lock on/off”).
Once the freezer zone has cooled down
to its set temperature, the ice maker will
fill with water.
As soon as the water is frozen, the ice
cubes drop out of the ice maker into the
ice container.
Ice production is halted automatically
as soon as the ice container is full.
After the Ice/Water dispenser has
been switched on, it can take up to
24 hours until the first serving of ice
cubes is ready.
After the appliance door has opened
and closed, it can take several sec-
onds until the Ice/Water dispenser is
ready for operation and the sensor
controls can be selected again.
Summary of Contents for F 2462 SF
Page 120: ......
Page 121: ......
Page 122: ......
Page 124: ...M Nr 11 508 660 01 en US CA F 2472 SF F 2672 SF ...
