Building in the appliance
^
Push the appliance into its housing
unit.
When doing this, make sure that the
mains cable does not get trapped.
^
Depending on the thickness of the
appliance housing unit walls, push
the appliance into the niche until
– the spacer piece touches the
housing unit wall
a
(16 mm thick
walls), – or the front edges of the
hinges are flush with the side walls of
the housing unit
b
(19 mm thick
walls).
The cover strip must
not
protrude in
front of the edge of the housing unit.
It must disappear completely into
the niche.
^
Push the hinged side of the
appliance to the furniture wall.
^
Align the appliance by altering the
height of the adjustable feet using the
spanner supplied
f
.
^
Secure plastic bracket
c
to the side
opposite the hinges using the M5 x
22 screws
d
.
^
Push the appliance in until the plastic
bracket is flush with the front edge of
the housing unit floor
e
.
^
To fix the appliance to the housing
unit at the top and bottom
– screw the 4 x 19 mm long chip board
screws
a
loosely into the hinge
plate,
Building in the appliance
40
Summary of Contents for F 456 i-3
