– screw two 4 x 19 mm long chip
board screws
b
loosely into the
middle of the long slot on the plastic
bracket and then turn the plastic
bracket downwards,
– Align cover strip
d
so that it is
parallel to the housing unit ceiling.
It must not protude.
– Fit screws
c
into cover strip
d
.
^
Close the appliance door.
Fitting a furniture door
^
A gap of 8 mm
a
must be set
between the appliance door and the
fixing bracket.
^
Push fitting aids
d
up to the height of
the furniture door: the lower edge "X"
of the fitting aids must be at the same
height as the upper edge of the
furniture door being fitted - see
-
on
the diagram.
^
Undo nuts
b
, and remove fixing
bracket
c
, together with the fitting
aids.
^
Using a pencil, mark a line down the
centre of the wrong side of the
furniture door.
^
Hang the fixing bracket with the
fitting aids
a
onto the
wrong side
of
the furniture door. Align the fixing
bracket centrally.
^
Attach the fixing bracket securely
using at least 6 short 4 x 14 mm chip
board screws
b
. (On cassette doors
only use 4 screws on the edges).
^
Pull the fitting aids upwards to
remove them
c
.
^
Turn them round and fit them back
into the middle slots on fixing bracket
d
.
Building in the appliance
41
Summary of Contents for F 456 i-3
