Repairs to electrical appliances
should only be carried out by a
suitably qualified and competent
person in strict accordance with
current local and national safety
regulations. Repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
Ensure that current is not supplied to
the appliance until after
maintenance or repair work has
been carried out.
Some minor problems can be corrected
without contacting the Miele Service
Department.
What to do if . . .
. . . the appliance does not get cool.
^
Make sure that the temperature dial is
not set at "0".
^
Check that the plug is correctly
inserted in the socket and switched
on.
^
Check that the fuse is not defective
and that the mains fuse has not
blown. If it has, contact the Miele
Service Department.
. . . the door will not open because it
has been opened and closed too
many times in succession.
This is not a fault. The suction caused
by opening and closing the door is
preventing the door from opening. Wait
a few minutes and then try again. It
should now open without force.
. . . the temperature is too low.
^
Turn the temperature dial to a lower
setting.
^
Super freeze has not yet switched
itself off. The Super freeze function
switches itself off automatically after
approx. 65 hours.
. . . the appliance is switching in too
frequently and for too long.
^
Check whether the ventilation gaps in
the plinth and in the housing unit at
the top have been covered over or
become too dusty.
^
The door has been opened too
frequently, or a large amount of fresh
food has been put in at once for
freezing.
^
Check that the door has been closed
properly.
^
Check to see whether a thick layer of
ice has built up in the freezer. If it
has, then the freezer will need
defrosting.
. . . the alarm sounds and the alarm
indicator light flashes.
The temperature in the freezer is too
warm, because
^
a large amount of food has been
frozen at once without switching on
the Super freeze function.
The alarm will stop and the indicator
light will go out when the temperature
has reached the correct level again.
^
the compressor is faulty. Call the
Service Department.
Problem solving guide . . ?
26
Summary of Contents for F 9212 I
Page 38: ...38 ...
Page 39: ...39 ...
Page 40: ...Alteration rights reserved 5006 F 9212 i M Nr 07 021 360 00 en GB ...