Building in the appliance
^
Remove cover
a
.
^
Secure bracket
b
with screws
c
(4.8 x 16 mm).
^
Push the appliance into the
building-in niche, leaving a gap of
approx. 4 mm.
Take care not to trap the mains cable.
^
Push in the appliance until the front
edges of bracket
b
and hinge plates
d
and
e
are flush with the front
edge of the housing.
^
Align the appliance height from above
on both sides using adjusting screw
f
.
^
Plug the gap between the appliance
and the furniture wall on the door
opening side with sealing strip
g
.
Press the sealing strip into the gap
starting at the bottom, and cut to
length so that it fits snugly to the
lower edge of bracket
b
.
Building in the appliance
36
Summary of Contents for F 9212 I
Page 38: ...38 ...
Page 39: ...39 ...
Page 40: ...Alteration rights reserved 5006 F 9212 i M Nr 07 021 360 00 en GB ...