^
Open the door.
^
Holding the door at the bottom and
on the handle side, carefully lift it
upwards and off.
The hinge pin
e
and washer
o
is
released from the hinge plate
d
. If it
does not release:
^
Press the hinge pin
e
with the
washer
o
out of the hinge plate from
below.
^
Undo screws
f
and take hinge plate
d
off.
^
Undo the screw of hinge part
g
on
hinge plate
d
slightly. Fit it into the
hole opposite in hinge plate
d
and
tighten up the screw.
^
Remove the plug
h
and place it in
the opposite retaining hole in the
hinge plate.
^
Remove cover
i
.
^
Unscrew and remove screw
j
and
refit it into the outer hole of the
opposite side.
^
Turn cover
i
through 180°, and fit it
into the holes on the other side.
^
Screw hinge plate
d
into position on
the opposite side using the two
outer
long slots only. Do not use the middle
hole because you will not be able to
align the door later on.
Changing the door hinging
35