11210610-01
Installation
*INSTALLATION*
Aligning the appliance door
The appliance door can be aligned with
the appliance housing after it has been
fitted.
In the following illustration the door is
not shown in the closed position to
make it easier to see what you have to
do.
To align the appliance door, use the
outer slots in the lower hinge plate:
Remove the centre screw
from the
hinge plate.
Slightly loosen both outer screws
.
Align the door by sliding the hinge
plate to the left or right.
Then tighten the screws
. The
screw
does not need to be refitted.
Electrical connection
The appliance is supplied with a mains
cable and moulded plug ready for
connection to an AC single-phase 220–
240 V 50 Hz supply.
The fuse rating must be at least 10 A.
This appliance must be connected to a
suitable switched socket. The electrical
installation must be in compliance with
current local and national safety
regulations.
The socket must not be concealed
behind the appliance and must be
easily accessible so that the appliance
can be quickly disconnected from the
electricity supply in case of an
emergency.
If the socket is no longer accessible
after installation, an additional means of
disconnection must be provided for all
poles. Suitable means of disconnection
include switches with an all-pole
contact gap of at least 3 mm. These
include isolator switches, fuses and
relays.
The mains plug and mains connection
cable must not come into contact with
the back of the appliance as vibrations
can cause damage to these
components. This could result in a short
circuit.
Nor should other appliances be
plugged into a socket located directly
behind this appliance.
