Using conventional functions
The conventional functions can be
used with or without the timer.
If you have set the timer to a specific
time the appliance will heat during this
time. At the end of the period a beep
sounds three times and the appliance
heating is switched off.
Fan heat
Turn the function selector to Fan heat
D
.
The cooling fan works and the oven in-
terior lighting is switched on.
Turn the temperature selector to the
required temperature.
Only turn the temperature selector
clockwise and then back again anti-
clockwise. Do not force it past the
resistance. Otherwise it could be
damaged.
The appliance begins to heat up. The
indicator light on the control panel
stays on while the appliance is heating
up.
Switching on the timer
You can switch the timer on at any time
to determine the length of time the fan
heat should be on. At the end of this
period the heating and the oven interior
lighting switch off.
Press the
g
button.
For approx. 4 seconds
0
•
00
ap-
pears in the display.
Within these 4 seconds use the + or –
button to set the required time.
The oven interior light and the heat-
ing will go out as soon as you press
the + or – button.
At the left side of the display
AUTO
flashes.
You can enter a time up to a maximum
of 99 minutes 59 seconds.
The time entered appears in the dis-
play in minutes
•
seconds.
Press the Start/Stop button.
The oven lighting goes on and the oven
begins to heat up. The indicator light
on the control panel stays alight while
the appliance heats up. The time en-
tered counts down. The
AUTO
symbol
stays on constantly at the left of the dis-
play.
Using conventional functions
25
Summary of Contents for H 152 MB
Page 2: ...Description of the appliance Control panel Appliance Description of the appliance 2 ...
Page 62: ...62 ...
Page 63: ...63 ...