11189580-08
Installation
*INSTALLATION*
Installing the cooker
For safety reasons, this appliance
must only be used after it has been
built in.
The cooker requires a sufficient
supply of cool air for efficient
operation. The required supply of
cool air must not be excessively
heated by other heat sources (e.g.
solid fuel stoves).
The following must be observed
when installing the appliance:
Make sure that the interim shelf that
the oven sits on does not touch the
wall.
Do not fit heat insulation strips to the
side walls of the housing unit.
Before installation
Ensure that there is no power to the
mains socket.
Follow the connection diagram
supplied with the cooker.
Remove the housing cover to
connect the single conductors of the
power cable to the connection
terminals.
All H 2xxx I cookers that are combined
with an induction cooktop are also
supplied with a ferrite ring.
With the
exception
of the earth
conductor, all other single conductors
of the power cable must be fed
through the opening of the ferrite ring
before attaching them to the
connection terminals.
Secure the single conductors to the
respective connection terminals.
Replace the housing cover.
