Installation, maintenance and repairs
to the electrical components of this
appliance should only be carried out
by a suitably qualified and
competent person in accordance
with national and local safety
regulations to ensure safety. Repairs
and other work by unqualified
persons could be dangerous. The
manufacturer cannot be held
responsible for unauthorised work.
Some minor problems however can be
dealt with as follows:
What to do if . . .
. . . the oven does not heat up.
Check whether,
^
the selector switch is set to the
function required,
and
the
temperature control is set at the
correct temperature.
^
the operating lock is activated.
^
the main fuse has blown. Contact a
qualified electrician or the Miele Ser-
vice Department.
. . . the heating works, but not the
light.
Make sure the halogen lamp is
connected properly in its socket.
If after checking it, it still does not work
you will need to change it:
^
Disconnect the appliance from the
electricity supply. Switch off at the
isolator or the mains fuse box.
Depending on the oven there will be
one or two slide access flaps on each
side trim of the oven.
^
Slide the relevant access flap
upwards.
^
Pull out the metal strip.
^
Replace the halogen lamp:
12 V, 20 W,
heat resistant up to 300°C, G4
socket, Osram, Type 64428.
Correcting minor faults
60
