Technical Information
22
H 408x BM
(F8) to electronic 3N1, which then cuts out.
An additional door safety switch (5F6/6) (Figure 011-8, Item 5) is located on
the left door lock and provides the electronic with the status of the position of
the front door. This switch can be tested in service mode.
If a safety switch needs to be replaced, the complete door lock has to be
replaced (refer to Section 011-4.8). The door safety switches cannot be
replaced individually.
Note:
As a matter of standard practice, the door switches must be adjusted after
completion of service or repair work on the door or the door lock. This ensures
that the door can be securely locked and that any microwave leakage is within
the permissible limits.
For this procedure, the complete door lock assembly must be installed.
The appliance must be disconnected from power.
Required parts:
3 blue magnetic shim strips, 1” x 2.8” x 0.03”, mat. no. 05055650
3 brown magnetic shim strips, 1” x 2.8” x 0.06”, mat. no. 05057340
1. Remove the appliance from its cabinet; see Section 011-4.3.
2. Remove the screws securing the appliance lid. Remove the lid.
Danger!
Before performing any service or repair work, discharge the high-voltage
capacitor. See Section A-2.
3. Remove the fascia panel. See Section 040-4.5.
4. Open the door.
5. Place 3 brown magnetic strips (0.06”) along the upper edge of the oven
cavity (Figure 011-7, Item 1).
6. Place 3 blue magnetic strips (0.03”) along the lower edge of the oven
cavity (Figure 011-7, Item 2).
7. Close the door.
8. Pull the connectors off safety switches 1F6/6 and 3F6/6 (refer to Figure
011-8, Items 1 and 3).
Summary of Contents for H 4080 BM
