^
Touch the OK sensor.
The water intake process will begin.
The amount of water actually drawn up
into the oven may be less than the
amount specified as required, leaving a
small amount in the container.
^
Remove the water container after the
water intake process.
^
Confirm the message telling you that
the process is complete by touching
the OK sensor.
^
Close the door.
The message will then disappear.
You will hear the pump briefly as the
remaining water in the water intake pipe
is drawn into the oven.
The oven heating will switch on.
After a short time a burst of steam is
injected automatically.
,
Danger of injury. Steam can
cause injury by scalding. Do not
open the appliance door while a
burst of steam is being injected.
Heat the empty oven for at least an
hour.
After at least an hour:
^
Switch the oven off.
After heating up for the first time
,
Danger of burning. Allow the
oven interior to cool down before
cleaning by hand.
^
Switch the oven on.
^
Touch
I
, to switch on the oven
interior lighting.
^
Take all accessories out of the oven
and clean them by hand (see
"Cleaning and care").
^
Clean the oven interior with a clean
sponge and a solution of hot water
and washing-up liquid or a damp
microfibre cloth.
^
Dry all surfaces with a soft cloth.
^
Switch the interior lighting and the
oven off.
Leave the oven door open until the
oven interior is completely dry.
Using for the first time
37
