The amount of water actually drawn up
into the oven may be less than the
amount specified as required, leaving a
small amount in the container.
^
Remove the water container after the
water intake process.
^
Confirm the message telling you that
the process is complete with OK.
^
Close the door.
The message will then disappear.
You will hear the pump briefly as the
remaining water in the water intake pipe
is drawn into the oven.
After a short time, a burst of steam is
injected automatically.
,
Danger of injury!
Steam can cause injury by scalding.
Do not open the appliance door
while a burst of steam is being
injected.
Heat up the oven for at least 1 hour.
After at least an hour:
^
Switch the oven off.
After heating up for the first time
,
Danger of burning!
Allow the oven interior to cool down
before cleaning by hand.
^
Switch the oven on.
^
Take all accessories out of the oven
and clean them by hand (see
"Cleaning and care").
^
Clean the oven interior with a clean
sponge and a solution of warm water
and washing-up liquid or a damp
microfibre cloth.
^
Dry all surfaces with a soft cloth.
^
Switch the oven off.
Leave the oven door open until the
oven interior is completely dry.
Using for the first time
39
Summary of Contents for H6890BP
Page 21: ...aOn Off sensor K bDisplay c I N sensors Oven controls 21 ...
Page 153: ...153 ...
Page 154: ...154 ...
