en
62
Press the
sensor contr
ol to start
vacuuming.
Quitting the current operating mode
Press the
Power
butt
on on the re-
mote control or the
sensor in the
contr
ol field for at least 3 seconds.
The robot vacuum cleaner will switch to
standby after appro
x. 60 seconds.
You can switch the robot vacuum
cleaner to standby befor
e 60 seconds
is up by pressing the
Power
butt
on
again.
The robot vacuum cleaner is reactivated
by pressing any button on the remote
control or one of the sensors in the con-
trol field.
Setting the timer
(only possible if the clock has been set)
If you would like the robot vacuum
cleaner to start at the same time every
day, you can save the start time and the
operating mode you want to memory.
The robot vacuum cleaner can also va-
cuum in the dark. However, please be
aware that vacuuming may be less thor-
ough. The cameras require light in order
to navigate unobstructed.
Use the remote control to set the timer.
Press the
Timer
butt
on briefly.
The timer
indicat
or flashes in the
control field and the hour display
flashes in the display.
Press the + or - direction button to
set the hour you want.
Press the
OK
butt
on to confirm your
selection.
The timer
indicat
or flashes in the
control field and the minute display
flashes in the display.
Summary of Contents for HS18
