Selecting further settings
48
Adjusting the display brightness
You can adjust the display brightness to
the lighting conditions in the room.
Tap
.
Swipe left or right until
is shown in
the middle.
Tap
.
Select the brightness you want by
swiping the segment bar to the left or
right.
Confirm the brightness you want by
tapping on the segment bar.
Switching off Demo mode
Demo mode
allows the refrigeration
appliance to be presented in the show-
room without the cooling system being
switched on. This setting is not needed
for domestic use.
If Demo mode has been switched on
as a default setting,
will show on the
start display.
Tap
.
Tap
.
Swipe left or right until
is shown in
the middle.
Tap
.
After Demo mode
has been switched
off, the refrigeration appliance shuts
down and must be switched on again.
Resetting the settings to their default
settings
All settings made on the refrigeration
appliance will be reset to default set-
tings (for settings, see “Guide to the ap-
pliance”).
Tap
.
Swipe left or right until
is shown in
the middle.
Tap
.
will appear on the display.
Tap
OK
.
The refrigeration appliance shuts down
and must be switched on again.
Information
Appliance data (model number and
serial number) is shown on the display.
Tip:
This data is important when report-
ing an appliance fault to the Miele Cus-
tomer Service Department (see “Ser-
vice”).