Selecting additional settings
75
Switching on the
Water Filter Display
If the
Water Filter Display
has been
switched off once, it must be switched
on again if required.
In Settings mode
, use the
and
sensor controls to select the
Water
Filter Display
and select
OK
to confirm
your selection.
Use the
and
sensor controls to
select
On
and select
OK
to confirm
your selection.
The
Water Filter Display
has been
switched on.
Switching off the
Water Filter Display
Risk to health due to contami-
nated water.
If the IntensiveClear 2.0 charcoal fil-
ter is not replaced on a regular basis,
it may become contaminated.
Only switch off the
Water Filter Display
if an external water filter has been at-
tached to your household water sup-
ply in place of the IntensiveClear 2.0
charcoal filter. In this case, you
should also use an IntensiveClear 2.0
mesh filter in place of the Intensive-
Clear 2.0 charcoal filter (see “Acces-
sories – Optional accessories”).
In Settings mode
, use the
and
sensor controls to select the
Water
Filter Display
and select
OK
to confirm
your selection.
Use the
and
sensor controls to
select
Off
and select
OK
to confirm
your selection.
The
Water Filter Display
has been
switched off.
Resetting the
Water Filter Display
After you have replaced or cleaned the
water filter, you must reset the
Water Fil-
ter Display
so that it can be displayed
again after 6 months.
If you do not reset the display, it ap-
pears again and again.
In Settings mode
, use the
and
sensor controls to select the
Water
Filter Display
and select
OK
to confirm
your selection.
Use the
and
sensor controls to
select
Reset
and select
OK
to confirm
your selection.
The
Replace the water filter
message dis-
appears from the display.
The
Water Filter Display
has been acti-
vated for the next time the water filter
requires cleaning or replacing.
