Adjusting the interior fittings (refrigerator section)
45
Adjusting the door shelf /
bottle shelf
Push the door/bottle shelf upwards,
then remove it by pulling it forwards
Replace the door/bottle shelf at the
required position. Ensure that it is se-
curely pushed back into position.
Moving the shelves
The shelves can be adjusted according
to the height of the food.
Raise the shelf, and pull it forwards
slightly until the notch at the side is in
line with the shelf support. It can then
be raised or lowered to the required
level.
The raised edge on the protective strip
at the back must face upwards to pre-
vent food from touching the back of the
appliance and freezing to it.
Stoppers prevent the shelves from be-
ing dislodged by mistake.
Adjusting or removing the
bottle holder
The bottle holder can be moved left or
right to create more room for drink car-
tons.
The bottle holder can be removed com-
pletely (e.g. for cleaning):
Pull the bottle holder upwards to re-
move it from the rear edge of the
bottle shelf.
The bottle holder can be replaced after
cleaning.
Summary of Contents for KFN 28032 D ws
Page 85: ......
Page 86: ......
Page 88: ...M Nr 10 360 590 00 en GB KFN 28032 D ws KFN 29042 D ws KFN 29032 D ws KFN 29032 D edo ...