Changing the door hinging
80
Lift lower door
off and place it
carefully to one side.
Changing the lower hinge plate
over
Pull hinge pin
complete with
washer and adjusting foot upwards to
remove.
Unscrew hinge plate
.
Remove stopper
from the hinge
plate.
Slightly loosen screw
of door clos-
ing aid
on hinge plate
.
Turn door closing aid
90° clock-
wise to the opposite locating hole in
the hinge plate.
Then tighten screw
up again.
Insert stopper
into the other hole.
Remove cover
and refit on the op-
posite side.
Secure hinge plate
into position on
the opposite side with screws
us-
ing the two outer long slots only. Do
not use centre screw
. The door
can only be aligned at a later point
using the outer long slots holes if the
centre screw is not replaced.
Insert hinge pin
complete with
washer and adjusting foot.
Important. The lug on the hinge pin
must point to the back again.
Summary of Contents for KFN 28032 D ws
Page 85: ......
Page 86: ......
Page 88: ...M Nr 10 360 590 00 en GB KFN 28032 D ws KFN 29042 D ws KFN 29032 D ws KFN 29032 D edo ...