Adjusting the interior fittings (refrigerator section)
48
Adjusting the door shelf /
bottle shelf
Push the door/bottle shelf upwards,
then remove it by pulling it forwards
Replace the door/bottle shelf at the
required position. Ensure that it is se-
curely pushed back into position.
Moving the adjustable
shelves / adjustable shelves
with lighting
The shelves can be adjusted according
to the height of the food.
Raise the shelf, and pull it forwards
slightly until the notch at the side is in
line with the shelf support. It can then
be raised or lowered to the required
level.
Push the shelf in until it clicks into po-
sition.
The raised edge at the back must face
upwards to prevent food from touching
the back of the appliance and freezing
to it.
Stoppers prevent the shelves from be-
ing dislodged by mistake.
Adjustable shelves with lighting
The LED lighting is located in the stain-
less steel trim of the adjustable shelves.
You can illuminate the refrigerator sec-
tion as you wish by moving the shelves.
Adjusting the bottle rack
The bottle rack can be placed at differ-
ent positions in the appliance.
Raise the bottle rack slightly at the
front, and pull it forwards a little until
the notch at the side is in line with the
shelf support. It can then be raised or
lowered to the required level.
The rear rail must face upwards to pre-
vent bottles from touching the back of
the appliance.
Stoppers prevent the bottle rack from
being dislodged by mistake.
