Installation
57
Solid wood / tiled / glass
worktops
a
Worktop
b
Cooktop
c
Gap
d
Wooden frame 13 mm (not supplied
with appliance)
As the ceramic glass and the worktop
cut-out have a certain dimensional
tolerance, the size of gap
can vary
(min. 1 mm).
Preparing the worktop
Make the worktop cut-out as shown
in “Building-in dimensions”. Observe
the safety distances (see “Safety
distances”).
Solid wood, tiled and glass worktops:
Fix the wooden frame
7 mm below
the top edge of the worktop (see
diagram).
Connecting the mains
connection cable to the
appliance
The mains connection cable must be
connected by a suitably qualified and
competent electrician in accordance
with current local and national safety
regulations.
Follow the instructions in the wiring
diagram (see “Electrical connection -
Wiring diagram”).
Installing the cooktop
Feed the mains connection cable
down through the cut-out.
Centre the cooktop in the cut-out.
Connect the cooktop to the mains
electricity supply.
Check that the cooktop works.
Seal the remaining gap
with a
silicone sealant that is heat-resistant
to at least 160 °C.
For natural stone worktops and
natural stone tiles, only use silicone
sealant that is specially formulated
for natural stone, and observe the
sealant manufacturer's instructions.
Summary of Contents for KM 6324-1
Page 61: ......
Page 62: ......
Page 64: ...M Nr 10 032 890 03 en AU NZ KM 6324 1 KM 6345 1 KM 6349 1 ...