^
Mark the distance
X
on the back-side
of the custom door.
^
Also calculate and mark the center of
the custom door
Y
.
^
Remove the mounting frame from the
appliance door and position it
according to the markings on the
custom door.
^
Pre-drill the holes.
^
Tightly screw on the bracket using
the pre-drilled holes:
Attach the bracket to each
attachment point with at least one
screw.
^
Attach the bracket at the top with at
least 5 screws:
The bracket includes a variety of holes
for the various design options of
custom doors.
When performing any work on the
custom door, always observe the
following:
– Always select the best load-bearing
surface of the custom door as the
location for screws.
– Select a screw length that is shorter
than the thickness of the door front.
Attaching and aligning the
custom door front
^
Fit the door handle to the custom
door.
Note that the screws are applied from
the reverse side.
^
Open the upper door and hang the
custom door with the adjusting rail
over the double-threaded bolts
p
.
^
Screw the nuts
q
a few turns onto
the double-threaded bolts.
Do not
tighten completely.
^
Close the door.
Installation
54
Summary of Contents for KWT 1601 Vi
Page 32: ...32 ...
Page 40: ...Niche dimensions Dimensions 40 ...
Page 41: ...Dimensions 41 ...
Page 63: ...63 ...
