Some of the standard settings for the
appliance (which are set at the factory)
have an alternative which you can
select if required.
Please consult the chart for the different
options. The factory settings are
marked with a star* on the chart.
Proceed as follows:
^
Touch
X
.
X
will flash in the display, and
P
and
0
will light up.
^
Touch OK.
P I
will appear in the display.
^
Use the rotary selector to select the
setting that you wish to change (
P I
to
P 11
and
P 0
). Turn it until the
setting required shows in the display.
^
Then touch OK to call up the setting.
The currently valid status appears in
the display, e.g.
S 1
etc.
^
Turn the rotary selector if you wish to
change the status (see chart), and
confirm your entry by touching OK
(for
P 8
and
P 0
, touch OK for
approx. 4 seconds).
The change is then stored in memory.
P
will appear in the display again,
together with the number for the setting.
The other settings can be changed in
the same way.
Touch
#
if you have not changed one
setting and wish to switch to another.
^
Touch
X
if you do not want to
change any more settings.
The altered settings are retained
after a power cut.
If there is too long a pause before the
next entry, the time of day reappears in
the display. If this happens, repeat
your entries.
Changing settings
60
Summary of Contents for M 6262 TC
Page 78: ...78 ...
Page 79: ...79 ...
Page 80: ...Alteration rights reserved 0813 M 6262 TC M Nr 09 569 560 02 ...