11196830-01
Installation
*INSTALLATION*
Electrical connection
Risk of injury caused by a faulty
appliance.
Before connecting the appliance,
ensure that it has not been damaged
in any way.
Never use a faulty appliance.
The appliance is supplied ready for
connection with a cable and plug.
Ensure that the protective contact
socket is easily accessible at all times.
If that is not possible, ensure that a
suitable means of disconnection is
provided on the installation side for
each pole.
Fire hazard due to overheating.
Connecting the appliance to a multi-
socket plug adapter or to an
extension lead can overload the
cable.
The appliance must not be used with
so-called energy-saving devices.
These reduce the amount of energy
supplied to the appliance, causing it
to overheat.
For safety reasons, do not use an
extension lead or multi-socket plug
adapter.
Connect the appliance directly to the
power supply using the original cable
and do not use any intermediate
elements.
The electrical installation must comply
with local regulations.
If the connection cable is damaged, it
must only be replaced with a specific
connection cable of the same type
(available from your Miele dealer). For
safety reasons, such replacement may
only be carried out by a qualified
technician or your Miele dealer.
The necessary connection data can be
found on the data plate located on the
front of the oven interior or on the back
of the appliance.
Compare the specifications on the data
plate with those of the electricity
supply. Make sure that they match.
If in any doubt, consult a qualified
electrician.
Temporary or permanent operation on
an autonomous power supply system or
a power supply system that is not
synchronised with the mains power
supply (e.g. island networks, back-up
systems) is possible. A prerequisite for
operation is that the power supply
system complies with the specifications
of EN 50160 or an equivalent standard.
The function and operation of the
protective measures provided in the
domestic electrical installation and in
this Miele product must also be
maintained in isolated operation or in
operation that is not synchronised with
the mains power supply, or these
measures must be replaced by
equivalent measures in the installation.
As described, for example, in the
current version of
BS OHSAS 18001–2 ISO 45001.
