Commissioning
27
Setting the
water hardness
level
The menu for setting the water hardness will then appear.
Water hardness
19
(0 - 70
°dH
°dH )
The possible range is shown in the bottom line of the display. Water
hardness setting values can be found in the “Water softener/Settings”
chart.
Your local water authority can give you information about the exact
water hardness in your area.
Where the water hardness fluctuates, e.g. between 1.4 – 3.1 mmol/l
(8 – 17 °dH), always programme the machine to the higher value,
3.1 mmol/l (17 °dH) in this example.
Set the water hardness using the arrow buttons
(higher) and
(lower) and touch
OK
to save.
Write down the water hardness in “Water softener/Water hardness”.
Select plumbing
connections
The menu for setting plumbing connections will then appear.
Unused plumbing connections, e.g. if there is only one connection,
can be deactivated here.
Following commissioning the plumbing connections can be
reinstated by Miele Service.
Plumbing connections
Cold water
Accept
The plumbing connection is set via multiple choice. A box
is shown
in the display next to all plumbing connections. If the connection is
activated, a tick
can be seen in it. Select to activate or deactivate
the plumbing connections.
Use the
and
arrow buttons to select the plumbing connection
you want. Plumbing connections are activated or deactivated by
touching
OK
.
To save the selection select the
Accept
option at the end of the list
and confirm with
OK
.
