Operation
56
Drying
The additional “Drying” function accelerates the drying process at the
end of the programme.
When the drying function is activated and the door is closed, the
drying system feeds heated and HEPA-filtered air into the wash
cabinet for active drying of the load. The heated air is discharged
through the steam condenser and can be cooled down if necessary
(see “Further settings/Air cooling”).
The drying function can be pre-selected for all programmes with a
drying phase or can be retrospectively switched on or off every time a
programme is selected (see “Settings
/ Drying”).
Drying is activated or deactivated prior to programme start by
pressing the
button. The LED in the
button indicates whether
the additional function is on or off. The drying time of the programme
can also be changed.
When the drying function is activated, the programme runs longer.
Activating and
deactivating drying
Select a programme.
Press the
button before the programme start.
If the drying time (
Drying time
) is set as changeable (
Time changeable?
)
in the programme settings, the drying time set can be altered.
Otherwise, the drying time set cannot be changed.
If drying is
deactivated
If the drying function has been previously deactivated, it can be
activated by pressing a button.
Drying
)
Min
(0 - 120
30
Min
If the time is set as changeable, the preset drying time for this
programme is shown in minutes (min) in the display and the possible
setting range is displayed in the bottom line.
Alter the drying duration using the arrow buttons
(higher) and
(lower), and save the setting with
OK
. Drying is now activated.
