Warning and Safety instructions
14
This machine complies with all statutory safety requirements.
Inappropriate use can, however, lead to personal injury and
material damage.
Read these instructions carefully before using it for the first time to
avoid the risk of accidents and damage to the machine.
Keep these instructions in a safe place where they are accessible
to users at all times.
Correct application
Use of the machine is only permitted for the applications expressly
approved in the operating instructions. Alterations or conversion of
the machine, or using it for purposes other than those for which it
was intended, are not permitted and could be dangerous.
The cleaning and disinfection processes are only designed for
laboratory glassware and utensils which are designated as
reprocessable by the manufacturer. The information provided by the
manufacturer of the load items must be observed.
This machine is intended for indoor use only.
Risk of injury
Please pay attention to the following notes to avoid injury
The machine may only be installed, commissioned, repaired and
maintained by the Miele Customer Service Department or a suitably
qualified service technician. A Miele service contract is recommended
to ensure full compliance with the normative and regulatory
provisions. Incorrect repairs can cause considerable danger to users.
Do not install the machine in an area where there is any risk of
explosion or of freezing conditions.
In order to reduce the risk of water damage, the area around the
machine should be limited to furniture and fittings that are designed
for use in commercial environments.
Some metal parts pose a risk of injury/being cut. Wear cut-
resistant protective gloves when transporting and setting up the
machine.
If the machine is built under, it must only be installed under a
continuous worktop run which is firmly secured to adjacent units to
improve stability.
The electrical safety of this machine can only be guaranteed when
correctly earthed. It is essential that this standard safety requirement
is met. If in any doubt, please have the on-site wiring system tested
by a qualified electrician. Miele cannot be held liable for the
consequences of an inadequate earthing system
(e.g. electric shock).
