Plumbing
*INSTALLATION*
162
Connecting the drain hose
- A non-return valve is incorporated into the drain system in the
machine to prevent drainage water flowing back into the machine
via the drain hose.
- The machine drainage hose should be connected to a
separate
drain for the machine only. If no separate drain is available, we
recommend connecting it to a dual-chamber siphon.
- The on-site connection point,
measured from the lower edge of
the machine
, should be positioned at a height between 0.3 m and
1.0 m. If it is lower than 0.3 m, the drain hose must be laid in a coil
at a height of at least 0.3 m.
- The drainage system must be able to accommodate a minimum
drainage flow of 16 l/min.
- The drainage hose is approx. 1.4 m (Australia and New Zealand:
2.25 m) long and flexible with an internal diameter of 22 mm. Hose
clips for the connection are supplied.
- The drain hose must not be shortened.
- The drain hose can be extended using a connection piece to attach
a further length of hose up to 4.0 m long. The drainage length must
not exceed 4.0 m.
- Drainage noise can be considerably reduced if the drainage hose is
positioned in an arc at a minimum height of 0.6 m and a max.
height of 1.0 m measured from the bottom edge of the washer-
disinfector.
See installation diagram supplied.
