en-CA - Notes
16
Changing the temperature unit (°C /
°F)
The temperature unit can be changed from
°C to °F by Miele Service.
Favorites setting
Using the "Favorites" button
, the most
used combination of temperature and roller
speed can be saved so that they can be ac‐
cessed quickly and easily.
To save the desired parameters, press and
hold the "Favorites" button
until it flashes
once. The saved values are then accessed
by pressing the "Favorites"
button briefly.
When you leave the "Favorites" function, the
previously saved values are restored again.
Increasing the life of the roller cov‐
er
During longer pauses in ironing, switch off
the ironer or press the "On / Off"
button
to enter Standby mode. This will considera‐
bly relieve the burden on the roller cover.
Avoid unnecessarily running the machine
without laundry. Do not restrict ironing of
smaller articles to any one part of the roll‐
er. Make use of the whole roller width.
If it is frequently used on only one side,
the heat is only absorbed on one side and
the roller cover will wear unevenly. If laun‐
dry is continuously fed in on one side of
the roller an infeed fault symbol will ap‐
pear in the display and an audible tone
will sound.
Power failure during ironing
In case of a power failure, the heater plate
disengages automatically. When power is
restored you need to restart the ironer by
pressing the
button.
In case of a longer power outage, the ironer
must be switched on again by pressing the
"On / Off"
button, operating the finger
guard and pressing the
button.
Peak load (option)
If the peak load option is active, the heating
of the ironer is switched off and "Tempera‐
ture" and "Roller speed" flash in the display.
Ironing can be continued using the residual
heat in the heating plate until the ironer
goes into "Pause"
mode.
Summary of Contents for PM 1210
Page 2: ...2 en CA 4 fr CA 23 ...
Page 22: ...fr CA Table des matières 22 Service après vente Miele 40 ...
Page 41: ......
