en - Warning and Safety instructions
156
The installation of the flatwork ironer in non-stationary locations (for example, on ships)
may be performed only by specialised companies/specialists if they can guarantee the
prerequisites for the safe use of the flatwork ironer.
The country-specific safety regulations and provisions, as well as standards, must be
taken into consideration.
Using accessories
Accessory parts may only be fitted when expressly approved by Miele. Using spare
parts or accessories from other manufacturers will invalidate the warranty, and Miele can-
not accept liability.
Coin operated ironers must be secured by the side columns to prevent the risk of the
machine tipping.
Notes on the use of this ironer
Only responsible people over the age of 16 years who have been fully trained in the use
of the ironer should use the infeed table.
When working with the ironer, always wear close fitting clothes and keep long hair tied
back. Wide sleeves, apron straps, scarves and ties etc. could be taken in by the roller.
Remove rings and bracelets before ironing.
Smooth out folds as far away from the infeed on the infeed table as possible. Feed pil-
low cases and duvet covers into the ironer with the open end first. Do not take hold of the
corners from the inside. Do not take hold of straps or ties etc. from the inside of garments
Check daily that safety devices are correctly set. This ironer must only be used if all
safety features are functioning correctly. This way you will avoid the danger of burns,
squashed fingers and even loss of hands.
Before switching to reverse make sure that nobody is endangered.
If other persons are being shown how to operate the ironer, they must be given or made
aware of these important safety instructions.
Pass these instructions on to any future users/owners of the ironer.
