Technisches Datenblatt / Technical datasheet: PW 6080 EL AV/LP
Datum / Date: 28.10.2009
Seite / Page: 9
Non-standard voltages:
OS 440
1. Standard voltage (as supplied)
V
3 AC 440
Frequency
Hz
60
Rated load
kW
7.9
Fuse rating
A
3 × 16
Connection cable cross-sectional area
mm²
4 × 1.5
Connection cable length
mm
2000
Connection cable without plug
(supplied as standard)
Electrical connection must be in accordance with local and
national regulations.
Plug and socket connection in accordance with IEC/EN
60309 and IEC/EN 60947 recommended to facilitate
electrical safety tests.
If the machine is connected via a fixed connection, a multi-
pole switch must be provided on site to ensure complete
isolation. Switches with a contact opening of more than 3 mm
should be used. Such switches are, e.g., LS switches, fuses
and contactors (IEC/EN 60947).
A wall socket or mains isolator must be visible and accessible
after installation.
A new connection, modification of an existing installation or
earth checking, including the determination of suitable fuse
rating, may only be carried out by a suitably qualified
electrician in accordance with all local and national
regulations.
Cold water
(soft water)
Min. flow pressure
kPa
100
Max. pressure
kPa
1000
Max. throughput
l/min
11
On-site connection thread according to DIN 44 991
Inch
¾" external thread
Length of connection hose
(parts supplied: 1 connection hose)
mm
1550
Water requirements (average for 60°C programme)
With standard connection (with hot water)
l/h
Approx. 70
If hot water supply is not available, a sufficient supply of cold
water must be ensured.
If connected to an alternative water supply (optional), subtract
cold water volume.
Hot water
(soft water)
Max. temperature
°C
70
Min. flow pressure
kPa
100
Max. pressure
kPa
1000
Max. throughput
l/min
11
On-site connection thread according to DIN 44 991
Inch
¾" external thread
Length of connection hose
(parts supplied: 1 connection hose)
mm
1550
Water requirements (average for 60°C programme)
l/h
Approx. 70
It is possible to connect the machine to a very hot water
supply with temperature from 70°C to max. 85°C. For this a
special connection hose is required. This special hose is
available from the Miele Spares Dept.
In addition, the Miele Service Dept. or an authorised dealer
must reprogram the machine accordingly.
If a hot water supply is not available, connect the hot water
hose to a cold water supply!
Alternative water
supply
(Optional)
Min. flow pressure
kPa
100
Max. pressure
kPa
1000
Max. throughput
l/min
11
On-site connection thread according to DIN 44 991
Inch
¾" external thread
Length of connection hose
(parts supplied: 1 connection hose)
mm
1550
Water requirements (average for 60°C programme)
l/h
Not yet available
